We Are Hiring Instructors!!! Check out our Careers Page for more info
Take a second to like us on Facebook, LinkedIn, and Subscribe to our email list
There are different circumstances where a backflow prevention assembly is tested, and this dictates the type and approval of the certification required in order to test them. Generally speaking, there are:
- Containment (Primary) valves are at the very beginning of domestic water and fire sprinkler systems that connect directly to the public water supply, these valves protect the public water supply from any potential contamination from the building
- Isolation (Secondary) valves are throughout the building(s) and connect the potable water supply to various non-potable sources such as Irrigation Systems, HVAC Make-Up Water, Hair and Nail Salon Tubs, Commercial Kitchen & Restaurant Equipment, and other sources. These valves protect the building occupants from any potential contamination from the building's own systems
Initial Test - Both Containment (Primary) and Isolation (Secondary) backflow assemblies must be tested upon installation and submitted to the Buildings Department to final the plumbing permit and receive a Certificate of Occupancy. These tests must be done in a manner consistent with the plumbing code and acceptable to the permit office, which sometimes but not always has to be by a tester licensed through the appropriate Department of Health or Environment for the State, if applicable. Quite often a tester can just test them in accordance with the plumbing codes and use their own test report form for the secondary assemblies, even with no certification at all, but usually some type of certificate is required, whether state recognized or other.
Annual Water Purveyor Test - The supplier of water in your area will also require the Containment (Primary) backflow assembly be tested periodically, usually annually but sometimes more frequently. These tests must be done by a tester licensed through the appropriate Department of Health or Environment for the State, if applicable.
Annual or Periodic Isolation (Secondary) Assembly Tests - If the building sublets units, goes on the market for sale, something similar, or has annual or periodic required inspections to renew their liability insurance, they will often need to have backflow survey inspections and assembly tests done for the entire building. Our Certification is Acceptable For These Purposes, being that they are unrelated to water purveyors and construction codes. We have a multi-state program based on ASSE 5000-2015 test procedures with recognized coursework and testing methods, and can submit credentials upon request.
Check out below your state's requirements for testing, and see if maybe we can service your needs. We also sell backflow kits and do calibrations - check out those offerings at www.krugerinstruments.com
Please NOTE - Our course is not affiliated with the Tennessee Department of Environment & Conservation. Our 40-hour course is based on the USC ( University of Southern California ) backflow textbook and test procedures, and the diploma would say as such. Our course would also be recognized as the pre-requisite for taking an ABPA exam, should the water purveyor accept this.
Backflow Prevention Assembly Testers, especially those working with water purveyors in the state, are regulated by the Tennessee Department of Environment and Conservation, and they generally do their own classes at the Fleming Training Center.
Do you need a backflow test kit or need to calibrate a test kit you already have? We offer both of these, check out our sister company Kruger Instruments for more information:
Copyright © 2024 Kruger's Training Academy - All Rights Reserved.
Powered by GoDaddy